Anycubic NTC 3950 100K Thermistor with 1 Meter Wiring and Female Pin Head for RepRap 3D Printer Heatbed or Hot End Pack of 5PCS

Specification:

– For 3D printers: use TEMP_SENSOR 11 in Marlin firmware

– Small Size: 1.25mmx2.0mm glass bead

– High accuracy: 1%

– Resistance value at 25°C=100K

– Wiring insulation: high temperature teflon/PTFE

– Wiring length: 1 meter

Package List:

5* NTC 3950 100k thermistor with female head

Product Features

  • Conviniently pre-wired with 1 meter long high temperature PTFE insulated wiring
  • Use it with heated bed or extruder
  • Temperature sensor 100KΩ accuracy of ± 1%
  • Pack of 5PCS

Click Here For More Information

Published by

3D Print Anything

3D Printing. The next Goldrush is on it´s way. Inside information on how to start printing in 3D, where to buy Printers, how to use them, and the newest Pictures and reviews of available 3D Printers.

3 thoughts on “Anycubic NTC 3950 100K Thermistor with 1 Meter Wiring and Female Pin Head for RepRap 3D Printer Heatbed or Hot End Pack of 5PCS”

  1. Bought these to replace the thermistor that was in my Monoprice Mini with e3d v6 head. One problem is they are about 1mm bigger than the tiny ones that fit in a normal e3d v6 heater block. My first attempt at making this work was to cement the thermistor in to a motherboard standoff and then screw that in to the screw hole on the block. Glued it in, let set for 24 hours and then tried to screw it in. Wrong threads. I believe the stock screw has coarse threads. Oh well. Next I just took…

Leave a Reply