[sg_popup id=1]

CCTREE 15PCS 3D Printer Heating Block Cotton with Kapton Tape Hotend Nozzle Heat Insulation Cotton for Ultimaker/Makerbot/Creality CR-10

Specification
Material: cotton
Cotton Size: 70mm x 20mm x 2mm
Kapton:Width 6mm, Lenght:33M
Feature: heat preservation

Note: this product only suitable for 3D printer using indoors

Attention: Small parts, keep away from children

Package including:
15PCS x 2mm heating block cotton
1PCS x6mm Kapton Tape

WARNING!!
1.3D printer replacement parts, Always shut off power to the circuit before starting installation work.
2.The surface temperature of the 3D printer might be high, and be careful not to touch the heating element to prevent injury.
3.3D printer initial operation, Do not run the equipment Unattended state.
4.When printing with a PLA(190°C-230°C) or ABS(230°C-250°C)consumable, if the temperature sensor and other accessories fail, it may cause high temperature hazards. Do not run the equipment Unattended state.
5.To ensure the users will use the product safely and properly, Please read your 3D printer manual first and follow the instructions step by step before using the product.
6.Due to the variety of possible end-uses, it is ultimately the responsibility of the customer to determine a product’s suitability for a particular application.

Product Features

  • Heat preservation, keep the printer heating evenly and work better
  • You can Punch Holes or Cut fit size to the cotton.
  • Recommend Safe Working Temperature : <300°C
  • Cotton Size: 70mm x 20mm x 2mm Kapton:Width 6mm, Lenght:33M
  • Package including:15PCS x 2mm heating block cotton + 1PCS x 6mm Kapton Tape

Visit The Website For More Information…

Published by

3D Print Anything

3D Printing. The next Goldrush is on it´s way. Inside information on how to start printing in 3D, where to buy Printers, how to use them, and the newest Pictures and reviews of available 3D Printers.

One thought on “CCTREE 15PCS 3D Printer Heating Block Cotton with Kapton Tape Hotend Nozzle Heat Insulation Cotton for Ultimaker/Makerbot/Creality CR-10”

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.