COLLENCE 3D Printer Heating Controller 30A Heatbed MKS MOSFET for Extruder MOS Module

Usage:
1. Plug a power supply.
2. Connect to heated bed.
3. Connect digital control signal to GND, D8 of MKS Mini.
4. Connect to the heated bed signal on Ramps1.4 or MKS series controller boards.

Notics:
1. Only can choose 3 or 4 signal group.
2. Pay attention to polarity.

Package includes:
1 x Heating Controllor MOS Tube

Product Features

  • Each one has been done functional test.
  • Superior performance of MOSFET (Max 280A).
  • Can use for hot bed, output signal of Ramp1.4 and MKS series to control.
  • Can use digital signal of 5-24v to control.
  • Extra large heat sink , the maximum current can be up to 30A or more.

Detailed Information available on our Homepage…

Published by

3D Print Anything

3D Printing. The next Goldrush is on it´s way. Inside information on how to start printing in 3D, where to buy Printers, how to use them, and the newest Pictures and reviews of available 3D Printers.

One thought on “COLLENCE 3D Printer Heating Controller 30A Heatbed MKS MOSFET for Extruder MOS Module”

  1. This is the same as the TriGorilla one I put in an earlier printer. This one went into a Monoprice Maker Select Plus printer.1st this board is large. I had to trim about a 1/4 inch off the circuit board to get it to fit in the Plus chassis. But with the extra wiring added to get the cables to reach, it was quite easy to wire up. It also takes a lot more current than my heat bed can produce to overwhelm it. It should be a good protection instead of the old connections running…

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.