eSUN 3mm Blue PLA PRO (PLA+) 3D Printer Filament 1KG Spool (2.2lbs), Actual Diameter 2.85mm +/- 0.05mm, Blue

eSUN 3D Printer Filament: PLA PRO 3mm

Size: 3mm nominal, 2.85mm +/-0.05mm actual

Extrusion Temperature Range: 210 to 225 Celsius

PLA PRO(PLA+) Advantages:

Superb layer bonding
High rigidity. Good glossiness.
Several times tougher than PLA
Smoother finished printouts.
No cracking or brittle problem.

PLA PRO prints about 20 Celsius higher than regular PLA and produces strong products.

Product Features

  • 1KG net (approximately 2.2 lbs) Filament with Clear Spool
  • eSUN PLA PRO 3D Printer Filament Vacuumed Sealed With Desiccant. Superb layer bonding. Several times stronger than PLA.
  • 3mm Filament. 2.85mm Actual Diameter (Dimensional Accuracy +/- 0.05mm)
  • Recommended Extrusion/Nozzle Temperature 210C – 225C
  • Spool Diameter: 8″ – Spool Width: 2.50″ – Spool Hub Hole Diameter: 2.05″ – Inner Circle Diameter: 3.5″

Check Out Our Website For Details…

Published by

3D Print Anything

3D Printing. The next Goldrush is on it´s way. Inside information on how to start printing in 3D, where to buy Printers, how to use them, and the newest Pictures and reviews of available 3D Printers.

2 thoughts on “eSUN 3mm Blue PLA PRO (PLA+) 3D Printer Filament 1KG Spool (2.2lbs), Actual Diameter 2.85mm +/- 0.05mm, Blue”

  1. Consistent, high quality filament at a fraction of the price! eSun has quickly become our go-to filament provider, with their translucent green PETG being the overall favorite. We’ve gone through at least 10 rolls of both 3mm and 1.75mm filament, and not one has had any tangles, creases or noticeable change in diameter or density. In addition to PETG, we’ve also used eSun ABS, PLA and PLA+, and all have been of the same high quality as the PETG. The PLA+ has a nice glossy finish, and is another favorite of ours and our 3D Hubs customers.You…

  2. Worth spending the extra $5 on this vs cheaper filaments Printed great, much better than the Monoprice black, that just jammed the printer. I thought I needed to print it hot, 200 degrees C, but 195 and 190 have been doing nicely. I’m printing on a mirror on a heated bed with gluestick, 60 degrees for the first layer, and 50 degrees after that, and it sticks great. I take the mirror off when it is done, and put it in the freezer, and the parts just pop off in 5 minutes.I like the reel, it has a small center, but has the space to the…

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.