General Add-on Heated Bed Power Expansion Module Electric Board for 3D Printer Parts

Features:

If your total power usage is 240W and you have 12V power supply, then it means at least 20A is needed (20X12=240W). As controller board is only capable of 15A this setting will not work. To make it work, you need this extra power module. This module under normal cooling is found stable work situation at I (Max) = 25A, the using current should not exceed 25A.

If you intend to use heated bed with your 3D printer that uses a 12V power supply, then this module is recommended, else it may cause excessive current during times which may burn the connectors on the controller board.

Color: Black

Max Current: 25A(Enhance heat dissipation)

Size: 6 x 5 x 3.1cm / 2.36 x 1.97 x 1.22″

Product Features

  • The page features A general add-on heated bed power expansion module high power module for 3D printer.
  • Helps 3D printer equipped with the controller board (capable of max 15A) become more powerful.
  • The maximum current will be up to 25A with this add-on module to board
  • Can be used in open 3D printer motherboards
  • Attention: If you intend to use heated bed with your 3D printer that uses a 12V power supply, then this module is recommended, else it may cause excessive current during times which may burn the connectors on the controller board.

Visit The Website For More Information…

Published by

3D Print Anything

3D Printing. The next Goldrush is on it´s way. Inside information on how to start printing in 3D, where to buy Printers, how to use them, and the newest Pictures and reviews of available 3D Printers.

Leave a Reply