Gizmo Dorks PEI Sheet 8″ x 8″ 1 mm 3D Printer Build Surface Ultem 1000

PEI (Polyetherimide) sheets provide a 3D printing build surface that requires no tape, slurry, or adhesive. ABS and PLA both stick extremely well to the surface, which eliminates the need for support rafts used for better adhesion.

How to Use:

Cut the PEI sheet to size by scoring with a hobby knife. There are two methods to attaching the PEI to your print bed. The first method is to just clamp the sheet to the print bed using binder clips. We find that 2 on each side works great.The second method, get 3M 468MP Transfer Tape and use it to stick the PEI to the print bed.

Once the PEI sheet is attached, re-level your print bed and you are ready to go!

It helps to wipe the surface down with isopropyl alcohol, methyl alcohol, or soap in between prints. This will ensure the PEI is clean, and help adhesion. Light sanding with 5000 grit paper will also give the PEI sheet more life.

Product Features

  • MADE IN THE USA: Single 1mm thick sheet installs quickly on top of existing flat build platforms (e.g. borosilicate glass)
  • ABS and PLA filaments (along with many other materials) print directly on to PEI surface without the need for additional adhesives, tapes, or slurry.
  • REMOVE FILM FROM BOTH SIDES BEFORE USING: Blue protective film guards against scratches during shipping and handling.
  • Reuse for multiple prints, just wipe down with isopropyl alcohol between prints for best results
  • Sheet can be easily cut down to desired size by scoring with a utility knife

Detailed Information available on our Homepage…

Published by

3D Print Anything

3D Printing. The next Goldrush is on it´s way. Inside information on how to start printing in 3D, where to buy Printers, how to use them, and the newest Pictures and reviews of available 3D Printers.

3 thoughts on “Gizmo Dorks PEI Sheet 8″ x 8″ 1 mm 3D Printer Build Surface Ultem 1000”

  1. This surface is by far the best i have tried when printing ABS, PLA, and PLA hybrids like wood, metallic. If you run the bed a little warmer than usual (65-70), the first layer lays down beautifully. As soon as the print finishes and the bed cools a bit (like 2 min tops), the part is easily removed from the surface by hand with no tools leaving a glass like finish to the bottom of your part. To get the best performance, i wipe the PEI down with an alcohol prep pad prior to every print. I…

Leave a Reply