NEXTPAGE High Glossy PLA 1.75mm 1KG 3D Printer Filament Dimensional Accuracy +/- 0.05mm, 2.2LBS Spool Black


Specification:

Material: GT-PLA.( New formulation, high glossy, tough, for none teflon tube inside hot end of 3d printer,like makerbot,UP,cube robo ,etc)
Color: Black
Diameter: 1.75mm
Roundness: +/-0.02mm
Diameter tolerance: + /-0.03mm
Print Temp: 195-210 degree Centigrade
Melt Flow Index: 6-8g/10 min
Melting Point: 145 degree Centigrade
Impact Strength: 20-35 kJ/m2
Flexural Strength: 65 Mpa
Flexural Modulus: 2100 Mpa
Elongation at Break: 500%
Tensile Yield: 60 Mpa
Impact Strength: 20-35 kJ/m2

Product Features

  • *Material: GT-PLA which is new formulation, high glossy, tough, for none teflon tube inside hot end of 3d printer, like makerbot, UP, cube robo, etc. Its extrusion-temperature is much lower than ABS, and most often doesn’t require a heated bed.
  • *1.75mm Filament Diameter (Dimensional Accuracy +/- 0.05mm)
  • *Recommended Extrusion/Nozzle Temperature 195°C – 210°C
  • *Spool Diameter: 8″ – Spool Width: 2.50″ – Spool Hub Hole Diameter: 1.25″
  • *Accurate diameter: 3.0/1.75mm, variations + /-0.03mm, roundness +/-0.02mm;

Detailed Information available on our Homepage…

Published by

3D Print Anything

3D Printing. The next Goldrush is on it´s way. Inside information on how to start printing in 3D, where to buy Printers, how to use them, and the newest Pictures and reviews of available 3D Printers.

2 thoughts on “NEXTPAGE High Glossy PLA 1.75mm 1KG 3D Printer Filament Dimensional Accuracy +/- 0.05mm, 2.2LBS Spool Black”

  1. I love this black PLA it is very good quality plastic. The roll is good quality and the color is jet black. There is no bad and patchy pigmentation it is all one solid color. Tangles are the worst for me since you could be in the middle of a 6-hour​ print. If there are tangles in the spool then it catches in the extruder build and prevents it from extruding. It is the absolute worst to wake up in the morning to check on a print and find it half done. This filament spool did not have…

  2. I received BeyondTek brand filament when I ordered this item. Apparently a few sellers are selling this BeyondTek manufacturer as their source, because I have received it before when ordering from another seller. It works OK. My 3D printer seems to like running it hotter than Hatchbox filament. I have it set at 220deg right now and it prints OK at that temp. I also have it slowed down a little.So what makes one filament better than another? It comes down to consistency. This…

Leave a Reply