TriGorilla MKS BASE V1.0 3D Printer Control Motherboard Compatible RepRap Ramps1.4 With USB Cable

Specification:
Can accept 24 v input, under the same system power can reduce the current hot bed to 1/4, effectively solve the problem of hot bed MOS tube heating
The firmware can use open source firmware Marlin, configuration are exactly the same with ramps1.4 , can be directly replace ramps1.4 also
Can be connected directly to Ramps1.4, 2004 LCD control board and the LCD board (12864)
Package Contents:
1 x MKS-BASE V1.0
1 x USB cable

Product Features

  • It gather all function on one board, which solved the Ramps1.4 combination interface problem, which easily out of order
  • Using 4982 as a motor drive, the SOP package, the effect of heat dispelling is better
  • Circuit board uses the high quality of 4 layer board,optimize heat dissipation;Ramp Is 2 layer board
  • Using special power supply chip, support the 12v-24v power input, solve the problem of Ramps voltage conversion of chip fever

Detailed Information available on our Homepage…

Published by

3D Print Anything

3D Printing. The next Goldrush is on it´s way. Inside information on how to start printing in 3D, where to buy Printers, how to use them, and the newest Pictures and reviews of available 3D Printers.

Leave a Reply